Home › Drivetrain › C551 (MANUAL TRANSMISSION / TRANSAXLE) › DIFFERENTIAL CASE › from 2020.07
RM36W0E _52 Drivetrain _091208 C551 MANUAL TRANSMISSION / TRANSAXLE _0432177 DIFFERENTIAL CASE A

C551 MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  REASSEMBLY  


PROCEDURE

Hide 41311 1.INSTALL FRONT DIFFERENTIAL CASE

a.

Coat the contact surfaces of the front differential side gears with gear oil.


b.
G021409

Install the 2 front differential side gear thrust washers to the 2 front differential side gears.


c.

Coat the contact surfaces of the front differential pinions with gear oil.


d.
G021410

Install the 2 front differential side gears, 2 front differential pinions and 2 front differential pinion thrust washers to the front differential case.

HINT:

While rotating the front differential side gears, install the 2 front differential pinions and 2 front differential pinion thrust washers.



e.

Coat the front No. 1 differential pinion shaft with MP grease.


f.
G021411

Install the front No. 1 differential pinion shaft to the front differential case so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case.


Hide 41342A 3.INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

a.
G021414

Using a pin punch and hammer, tap in the front differential pinion shaft straight pin to the front differential case.


b.
G021556

Using a hammer and chisel, stake the pin holes around the circumference of the front differential case.


Hide 41221 4.INSTALL FRONT DIFFERENTIAL RING GEAR

a.

Clean the contact surfaces of the front differential case and ring gear.


b.
C166738

Using a heater, heat the front differential ring gear to 90 to 110°C (194 to 230°F).


c.
G021558C05
2.563,1 2.917,0.521 2.917,0.521 2.656,1.01 false 2.948,0.375 3.167,0.573 0.219,0.198 10 false *a
*a Matchmark


After the moisture on the front differential ring gear has completely evaporated, quickly align the matchmarks on the front differential ring gear and front differential case and install the front differential ring gear to the front differential case.


d.

Install the new 6 bolts.

Torque:
124 N*m (1264 kgf*cm, 91 ft.*lbf)


Hide 41311F 5.INSTALL FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING

a.
G021559E04
1.031,0.479 0.531,0.469 0.531,0.469 0.948,0.781 false 0.125,0.354 0.427,0.542 0.302,0.188 10 false SST

Using SST and a press, install the front differential case rear tapered roller bearing to the front differential case.

SST
09350-32014  (09351-32120, 09351-32140)


Hide 41311E 6.INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING

a.
F100233E02
0.959,0.365 0.574,0.356 0.574,0.356 0.882,0.596 false 0.201,0.239 0.505,0.404 0.304,0.165 10 SST

Using SST and a press, install front differential case front tapered roller bearing to the front differential case.

SST
09350-32014  (09351-32120, 09351-32140)