Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL POWER SUPPLY › from 2020.07
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0432240 BRAKE CONTROL POWER SUPPLY A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL POWER SUPPLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake control power supply assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 89680 3.REMOVE BRAKE CONTROL POWER SUPPLY ASSEMBLY

NOTICE:
·

Do not hold the brake control power supply assembly by the connector.

·

Do not drop the brake control power supply assembly when carrying it.



a.

Turn back the floor carpet.


b.
C436328C01
1.229,2.646 1.5,2.25 1.5,2.25 1.667,2.25 true 1.708,2.167 2.021,2.365 0.313,0.198 10 false *a
*a Lock Lever


Remove the 2 bolts and disengage the hook to remove the brake control power supply assembly.


c.

Disconnect the brake control power supply assembly connector.

i.

Disengage the claw and raise the lock lever to disconnect the brake control power supply assembly connector as shown in the illustration.

NOTICE:

After disconnecting the brake control power supply assembly connector, make sure that dirt, water or other foreign matter does not contact the connecting parts of the brake control power supply assembly connector.




Hide 89686 4.REMOVE NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET

a.
C436329

Remove the 4 bolts and No. 1 brake control power supply bracket.

NOTICE:
·

Do not hold the brake control power supply assembly by the connector.

·

Do not drop the brake control power supply assembly when carrying it.