Home › Drivetrain › K320 (MULTIDRIVE / CVT) › SHIFT LEVER (for TMMF Made) › from 2020.07
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0432243 SHIFT LEVER(for TMMF Made) A

K320 MULTIDRIVE / CVT  SHIFT LEVER(for TMMF Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
·
C332327

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 33554 2.REMOVE SHIFT LEVER CAP

a.
C439386C01
2.292,1.479 2.021,1.292 true 2.302,1.396 2.5,1.594 0.198,0.198 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to remove the shift lever cap from the position indicator housing.

NOTICE:
·

When removing the shift lever cap, if the screwdriver is lowered in the direction opposite to the one shown in the illustration, the cap could be damaged as a result.

·

Be careful not to damage the shift lever cap and position indicator housing.




Hide 33504F 3.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58910C 4.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 33820B 5.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C435101

Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.


c.
C435102C02
1.156,2.604 1.531,2.948 true 0.49,2.646 0.802,2.844 0.313,0.198 10 false *a 1.552,2.938 1.865,3.135 0.313,0.198 10 false *1
*1 Nut
*a Counterclockwise


Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.


Hide 6.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

a.
C439388

Disconnect the transmission control switch connector.


b.

Disconnect the connector.


c.

Disengage the clamp.


d.
C439389

Disconnect the shift lock control ECU connector.


e.

Disengage the 2 clamps to disconnect the wire harness from the transmission floor shift assembly.


f.
C439387

Remove the 4 bolts and transmission floor shift assembly from the vehicle body.