Home › Drivetrain › K320 (MULTIDRIVE / CVT) › VALVE BODY ASSEMBLY › from 2020.07
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0422072 VALVE BODY ASSEMBLY A

K320 MULTIDRIVE / CVT  VALVE BODY ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission valve body assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)
Replacement of transmission valve body assembly
1.

Reset memory

2.

Transaxle compensation code (Initialize)

3.

CVT oil pressure calibration


·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:
(Click here)
for Registration:
(Click here)

HINT:

Shift shock may increase after replacing the transmission valve body assembly. In this case, shift shock will reduce as the vehicle is driven.


PROCEDURE

Hide 35015Y 1.REMOVE TRANSAXLE SIDE COVER SUB-ASSEMBLY

Hide 35410J 2.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

a.

Move the shift lever to D.


b.
C429261

Disengage the clamp to disconnect the transmission wire from the solenoid lock plate.


c.

Disconnect the 6 solenoid valve connectors.


d.
C399125

Remove the bolt and temperature sensor clamp from the transmission valve body assembly.


e.

Disconnect the temperature sensor from the transmission valve body assembly.


f.
C395524

Remove the O-ring from the temperature sensor.


g.
C434349

Remove the 11 bolts and transmission valve body assembly from the transaxle case sub-assembly.

NOTICE:

Make sure the manual valve does not fall out when removing the transmission valve body assembly, as the manual valve is not secured to the transmission valve body assembly.



h.
C429263

Remove the front oil pump cover gasket from the transaxle case sub-assembly.


i.

w/ Stop and Start System:

i.
C440323

Remove the 4 transaxle case gaskets from the transaxle case sub-assembly.



j.

w/o Stop and Start System:

i.
C434350

Remove the 3 transaxle case gaskets from the transaxle case sub-assembly.