Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
33554
2.REMOVE SHIFT LEVER CAP
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to remove the shift lever cap from the position indicator housing.
When removing the shift lever cap, if the screwdriver is lowered in the direction opposite to the one shown in the illustration, the cap could be damaged as a result.
Be careful not to damage the shift lever cap and position indicator housing.
33504F
3.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
58910C
4.REMOVE REAR CONSOLE BOX ASSEMBLY
33820B
5.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.
| *1 | Nut |
| *a | Counterclockwise |
Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.
6.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
Disconnect the connector.
Disengage the clamp.
Disconnect the shift lock control ECU connector.
Disengage the 2 clamps to disconnect the wire harness from the transmission floor shift assembly.
Remove the 4 bolts and transmission floor shift assembly from the vehicle body.