Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for Gasoline Model RHD) › from 2020.07
RM36W0E _54 Brake _088656 BRAKE SYSTEM (OTHER) _0432262 BRAKE PEDAL(for Gasoline Model RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for Gasoline Model RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

NOTICE:
·

When disassembling the brake pedal support assembly, do not loosen the breakaway bolt at the time of collisions.

·

If the breakaway bolt at the time of collisions is loosened, replace with a new brake pedal support assembly.



HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1.REMOVE STEERING COLUMN ASSEMBLY

Hide 84340 2.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 3.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 47101A 4.REMOVE BRAKE PEDAL RETURN SPRING

a.
C429814

Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.


Hide 47264A 5.REMOVE PUSH ROD PIN

a.
C429816

Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.


Hide 47110 6.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C429822

Disengage the clamp to separate the wire harness from the brake pedal support assembly.


b.
C429818

Disengage the 3 clamps to separate the wire harness from the brake pedal support assembly.


c.
C429823

Remove the 2 clips.


d.

Remove the 2 nuts, 2 bolts and brake pedal support assembly.


Hide 47121 7.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.