Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0432441 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made)  C00631F  Yaw Rate Sensor Circuit Intermittent  C006396  Yaw Rate Sensor Component Internal Failure  C05201F  Multi-axis Acceleration Sensor Module "A" Circuit Intermittent  


DESCRIPTION

The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

These DTCs are stored when the skid control ECU (brake actuator assembly) receives a malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C00631F Yaw Rate Sensor Circuit Intermittent Yaw rate sensor signal invalid condition continues for 2.5 seconds or more. Yaw rate sensor (airbag sensor assembly) Brake
C006396 Yaw Rate Sensor Component Internal Failure Yaw rate sensor signal does not fulfill execution requirements for 2.5 seconds or more. Yaw rate sensor (airbag sensor assembly) Brake
C05201F Multi-axis Acceleration Sensor Module "A" Circuit Intermittent
·

Longitudinal acceleration signal is invalid for 2.5 seconds or more.

·

Lateral acceleration signal is invalid for 2.5 seconds or more.

·

Lateral acceleration signal is abnormal for 0.01 second or more.

·

When the ignition switch has been turned ON and the vehicle has been driven at 5 km/h (3 mph) or more for 5 seconds or more, the acceleration sensor signal condition is unregistered or initialized for 0.01 second or more.

·

When the ignition switch has been turned ON and the vehicle has been driven at 5 km/h (3 mph) or more for 5 seconds or more, the lateral acceleration signal does not fulfill execution requirements for 0.1 second or more.


Acceleration sensor (airbag sensor assembly) Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform yaw rate and acceleration sensor zero point calibration and store system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made)>UTILITY


PROCEDURE

1.REPLACE AIRBAG SENSOR ASSEMBLY

NEXT

END