The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly and tail exhaust pipe assembly removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
17430
1.REMOVE TAIL EXHAUST PIPE ASSEMBLY
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the 2 bolts and 2 compression springs and disconnect the tail exhaust pipe assembly from the front exhaust pipe assembly.
Remove the tail exhaust pipe assembly from the 2 exhaust pipe supports.
Remove the exhaust pipe gasket from the front exhaust pipe assembly.
89467C
2.REMOVE NO. 2 AIR FUEL RATIO SENSOR
17410
3.REMOVE FRONT EXHAUST PIPE ASSEMBLY
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly from the exhaust manifold.
Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the exhaust pipe gasket from the exhaust manifold.