The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cam timing control motor with EDU assembly connector removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
2.REMOVE ENGINE WIRE
Remove the 2 bolts.
Disconnect the clamp and remove the engine wire from the engine assembly.
13090E
3.REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
Disconnect the cam timing control motor with EDU assembly connector.
Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing chain cover assembly.
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.
13090E
4.REMOVE CAM TIMING CONTROL MOTOR O-RING
Remove the cam timing control motor O-ring from the No. 2 timing chain cover assembly.