Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84345
1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
Engage the claw to install a new stop light switch mounting adjuster.
84340
2.INSTALL STOP LIGHT SWITCH ASSEMBLY
| *1 | Stop light switch mounting adjuster |
Insert the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.
Do not depress the brake pedal.
| *a | Protrusion Amount Measurement Area |
Turn the stop light switch assembly clockwise by approximately one fourth of a rotation.
for LHD:
Check the protrusion amount of the shaft.
0.6 to 2.5 mm (0.0236 to 0.0984 in.)
for RHD:
Check the protrusion amount of the shaft.
0.5 to 2.6 mm (0.0197 to 0.1024 in.)
Connect the connector.
55606
3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY