When the windshield washer motor and pump assembly receives signals from the windshield wiper switch assembly, it operates to spray washer fluid from the washer nozzle sub-assemblies.
Inspect the fuses of circuits related to this system before performing the following procedure.
The wiper and washer system uses the CXPI communication system. First, confirm that there is no malfunction in the CXPI communication system.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Washer Relay | Function to operate the windshield washer motor and pump assembly (Front) | OFF or ON | - |
| Rear Washer Relay | Function to operate the windshield washer motor and pump assembly (Rear) | OFF or ON | - |
| Tester Display |
|---|
| Front Washer Relay |
| Tester Display |
|---|
| Rear Washer Relay |
Windshield washer motor and pump assembly operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
OK
NG
Disconnect the A50 windshield wiper relay assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A50-6 (IGWS) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A50-5 (EWS) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A50-1 (+WR) - A44-1 (B) | Always | Below 1 Ω |
| A50-7 (-WR) - A44-2 (SW) | Always | Below 1 Ω |
| A50-1 (+WR) or A44-1 (B) - Body ground | Always | 10 kΩ or higher |
| A50-7 (-WR) or A44-2 (SW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD: Click hereVehicle Exterior>WIPER / WASHER>WIPER ECU (for LHD)>REMOVAL
for RHD: Click hereVehicle Exterior>WIPER / WASHER>WIPER ECU (for RHD)>REMOVAL
NG