Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0432441 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made)  U030051  Internal Control Module Software Incompatibility Not Programmed  


DESCRIPTION

When the vehicle information is not registered to the skid control ECU (brake actuator assembly), the following DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U030051 Internal Control Module Software Incompatibility Not Programmed Vehicle information registration has not been performed.
·

CAN communication system

·

Skid control ECU (brake actuator assembly)


Brake

PROCEDURE

1.CHECK DTC OF OTHER COMPONENTS (CAN COMMUNICATION SYSTEM)
a.

Operate the GTS, and check for DTCs related to the CAN communication system.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM


Result:
Result Proceed to
Any CAN communication system relating DTCs are output A
None of the above conditions are met B



A

B

2.CHECK DTC (HEALTH CHECK)
2.CHECK DTC (HEALTH CHECK)
a.

Operate the GTS to perform Health Check.


b.

Check DTCs.

OK:

DTCs indicating a vehicle information mismatch with the skid control ECU (brake actuator assembly) are not output by any ECU.



c.

Turn the ignition switch off.


Result:
Proceed to
OK
NG



OK

3.CLEAR SYSTEM INFORMATION DATA

NG

3.CLEAR SYSTEM INFORMATION DATA
a.

Clear the zero point calibration data and system information.

Chassis > Brake > Utility
Tester Display
Reset Memory
50005 435 4560
Result:
Proceed to
NEXT




NEXT

4.PERFORM ZERO POINT CALIBRATION
4.PERFORM ZERO POINT CALIBRATION
a.

Operate the GTS to perform "Calibration" and store system information memorization.

Chassis > Brake > Utility
Tester Display
Calibration
50005 435 4554
Result:
Proceed to
NEXT




NEXT

5.CLEAR DTC
5.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

b.

Operate the GTS to clear the codes.

Chassis > Brake > Clear DTCs
50002 435

Post-procedure1

c.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

6.RECONFIRM DTC
6.RECONFIRM DTC
a.

Operate the GTS to read the DTCs.

Chassis > Brake > Trouble Codes
50001 435

b.

Check if the same DTC is output.


Result:
Result Proceed to
U030051 is not output A
U030051 is output B



A

END

B