Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › 2020.07–2020.09
RM36W0E _56 Audio / Visual / Telematics _091907 TELEMATICS _0434308 TELEMATICS SYSTEM(for eCall) C

TELEMATICS  TELEMATICS SYSTEM(for eCall)  B15C511  Emergency Call Switch Circuit Short to Ground  B15C513  Emergency Call Switch Circuit Open  


DESCRIPTION

If the telephone transceiver assembly detects an error in the communication between the telephone transceiver assembly and the map light assembly (manual (SOS) switch) as a result of the telephone transceiver assembly self check, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C511 Emergency Call Switch Circuit Short to Ground Manual (SOS) switch impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON
·

Map light assembly

·

Harness or connector

·

Telephone transceiver assembly


B15C513 Emergency Call Switch Circuit Open Manual (SOS) switch impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON
·

Map light assembly

·

Harness or connector

·

Telephone transceiver assembly



WIRING DIAGRAM

E231377E86
0.573,2.073 0.969,2.26 0.396,0.188 10 false H85 5.052,2.063 5.448,2.25 0.396,0.188 10 false V6 0.573,2.24 2.771,2.479 2.198,0.24 10 false Telephone Transceiver Assembly 5.052,2.208 6.865,2.615 1.813,0.406 10 false Map Light Assembly (Manual (SOS) Switch) 5.375,0.792 5.771,0.979 0.396,0.188 10 false SIG1 5.396,1.594 5.823,1.781 0.427,0.188 10 false GND3 1.438,0.792 1.833,0.979 0.396,0.188 10 false SIG1 1.448,1.594 1.802,1.781 0.354,0.188 10 false SIG- 1.844,0.698 2.094,0.885 0.25,0.188 10 false 21 1.844,1.479 2.094,1.667 0.25,0.188 10 false 3 5.135,0.667 5.344,0.854 0.208,0.188 10 false 12 5.125,1.469 5.333,1.656 0.208,0.188 10 false 16

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System (for eCall).

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>PRECAUTION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Turn the ignition switch to ON and wait for 10 seconds or more.


b.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 459

Result:
Result Proceed to
DTCs are not output A
DTC B15C511 or B15C513 is output B



A

B

3.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)
3.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)
a.
E426031C20
1.531,0.167 1.958,0.417 0.427,0.25 1.969,1.76 1.823,1.385 true 0.833,1.76 1.021,1.385 true 0.188,0.167 0.5,0.365 0.313,0.198 10 false *a 0.604,1.792 1.052,2.042 0.448,0.25 10 false GND3 1.844,1.792 2.292,2.042 0.448,0.25 10 false SIG1 1.656,0.219 1.969,0.417 0.313,0.198 10 false V6
*a Component without harness connected
(Map Light Assembly (Manual (SOS) Switch))


Remove the map light assembly (manual (SOS) switch).

HINT:

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL



b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
V6-12 (SIG1) - V6-16 (GND3) Manual (SOS) switch not operated 407.8 to 416.1 Ω
V6-12 (SIG1) - V6-16 (GND3) Manual (SOS) switch operated 81.1 to 82.8 Ω



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH))

NG

REPLACE MAP LIGHT ASSEMBLY

4.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH))
a.

Disconnect the H85 telephone transceiver assembly connector.


b.

Disconnect the V6 map light assembly (manual (SOS) switch) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H85-21 (SIG1) - V6-12 (SIG1) Always Below 1 Ω
H85-3 (SIG-) - V6-16 (GND3) Always Below 1 Ω
H85-21 (SIG1) or V6-12 (SIG1) - Body ground Always 10 kΩ or higher
H85-3 (SIG-) or V6-16 (GND3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL



Result:
Proceed to
NEXT



NEXT