The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the telematics transceiver removal/installation are shown below.
55900
1.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
55406B
2.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER (for Manual Air Conditioning System)
3.REMOVE TELEMATICS TRANSCEIVER WITH BRACKET
Disconnect the 4 connectors.
Disengage the 1 clamp to remove the telematics transceiver with bracket.
Remove the 2 bolts.
Disengage the 2 guides.
Remove the telematics transceiver with bracket.
86719A
4.REMOVE NO. 1 TELEPHONE BRACKET
Remove the screw.
Disengage the No. 1 telephone bracket.
86719B
5.REMOVE NO. 2 TELEPHONE BRACKET
Remove the screw.
Disengage the No. 2 telephone bracket.