DTCs may be stored during the inspection procedure. Be sure to clear the DTCs and check that no DTCs are output after the inspection is finished.
47210L
1.INSPECT BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
| *a | Pedal Effort Gauge |
| *b | SST (LSPV Gauge) |
| *c | SST (No. 3 Nipple) |
Remove the front disc brake cylinder bleeder plug and set a pedal effort gauge and SST.
Bleed air from SST (LSPV gauge).
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model TMMF Made)>BLEEDING
Shift lever in P and the parking brake applied.
Turn the ignition switch ON (READY), check the hydraulic pressure by depressing the brake pedal.
| Pedal Effort | Hydraulic Pressure |
|---|---|
| 50 N (5 kgf, 11.2 lbf) | 2.8 MPa (28.6 kgf/cm2, 406 psi) |
| 100 N (10 kgf, 22.5 lbf) | 5.8 MPa (59.1 kgf/cm2, 841 psi) |
| 150 N (15 kgf, 33.7 lbf) | 6.8 MPa (69.3 kgf/cm2, 986 psi) |
| 200 N (20 kgf, 45.0 lbf) | 7.2 MPa (73.4 kgf/cm2, 1044 psi) |
Remove the pedal effort gauge and SST, and bleed the brake line.
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model TMMF Made)>BLEEDING
If the result is not as specified, replace the brake booster with master cylinder.
for LHD
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model LHD)>REMOVAL