Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0435240 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made)  C05201C  Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range  


DESCRIPTION

The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

When the skid control ECU (brake actuator assembly) detects an abnormal acceleration sensor (airbag sensor assembly) signal, or the control value calculated using the acceleration sensor (airbag sensor assembly), yaw rate sensor (airbag sensor assembly), steering sensor and speed sensor are compared and judged to be abnormal, this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C05201C Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range
·

When the vehicle is being driven and the stop light switch assembly is OFF, the value (longitudinal) of the acceleration sensor (airbag sensor assembly) is less than -4.0 m/s2 or more than 4.0 m/s2 for 20 seconds or more.

·

When the vehicle is being driven, the difference in the acceleration value (longitudinal) calculated using the speed sensors and the acceleration value of the acceleration sensor (airbag sensor assembly) is less than -3.5 m/s2 or more than 3.5 m/s2 for 4 seconds or more.

·

When the vehicle is being driven in a straight line, the calculated lateral acceleration value based on the speed sensors, steering sensor angle and yaw rate sensor (airbag sensor assembly) differs from the value (lateral) of the acceleration sensor (airbag sensor assembly).


Acceleration sensor (airbag sensor assembly) Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform acceleration sensor zero point calibration and store system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made)>UTILITY


PROCEDURE

1.REPLACE AIRBAG SENSOR ASSEMBLY
a.

Replace the yaw rate and acceleration sensor (airbag sensor assembly).

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL


Result:
Proceed to
NEXT



NEXT

END