The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the telematics transceiver removal/installation are shown below.
Risk of explosion if the battery is replaced by an incorrect type.Replace battery with thesame type.
Risk of explosion or the leakage of flammable liquid or gas.
Do not use in /store in /bring into environment of extremely high temperature orextremely low pressure due to the very high altitude.
Do not attempt to burn, crush, or cut used battery.
86740
1.REMOVE TELEMATICS TRANSCEIVER
86725
2.REMOVE MOBILEPHONE BATTERY
Disengage the 4 claws to remove the cover.
Disconnect the connector.
Remove the mobilephone battery.