The skid control ECU (brake booster with master cylinder assembly) detects a drop in accumulator pressure according to the signals from the accumulator pressure sensor, then operates and stops the motor relay as well as the pump motor.
The skid control ECU (brake booster with master cylinder assembly) troubleshoots the built-in motor relay drive circuit, and stores this DTC when a malfunction is detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C141C49 | Brake Booster Motor "A" Control Internal Electronic Failure | After hard pump motor operation, when the accumulator pressure is less than 15.3 MPa (156 kgf/cm2, 2219 psi), the pump motor does not operate for 1 second or more. | Skid control ECU (brake booster with master cylinder assembly) | Brake |
| C141F7F | Brake Booster Motor "A" Control Actuator Stuck Off | When a motor relay drive test is being performed, one or both motor relays do not operate for 0.2 seconds or more. | Skid control ECU (brake booster with master cylinder assembly) | Brake |
After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
| Proceed to |
|---|
| NEXT |
NEXT