Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMC Made) › 2020.07–2020.09
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0440901 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMC Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMC Made)  C124A00  ECM Communication  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C124A00 ECM Communication Any of the following is detected:
·

The engine type, powertrain variation and destination information sent from the ECM do not match the information stored in the skid control ECU (brake actuator assembly).

·

No system information stored in the skid control ECU (brake actuator assembly).

·

When the skid control ECU (brake actuator assembly) is malfunctioning.


·

Incorrect ECM installed

·

Skid control ECU (Brake actuator assembly)


Brake

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMC Made)>CALIBRATION

·

Before replacing the ECM, refer to Service Bulletin.



PROCEDURE

1.CHECK PART NUMBER (ECM)
a.

Check that the proper ECM is installed.

OK:

Proper ECM is installed.



b.

Check if the ECM was replaced before the DTC was stored.

OK:

ECM was not replaced



Result:
Result Proceed to
OK A
NG (A proper ECM is not installed and/or the ECM was replaced) B



A

2.CHECK PART NUMBER (BRAKE ACTUATOR ASSEMBLY)

B

2.CHECK PART NUMBER (BRAKE ACTUATOR ASSEMBLY)
a.

Check that the proper brake actuator assembly is installed.

OK:

Proper brake actuator assembly is installed.



b.

Check if the brake actuator assembly was replaced before the DTC was recorded.

OK:

The brake actuator assembly was not replaced.



Result:
Result Proceed to
OK A
NG (The brake actuator assembly was replaced) B
NG (A proper brake actuator assembly is not installed) C



A

3.CLEAR DTC

B

5.CHECK CALIBRATION

C

3.CLEAR DTC
a.

Operate the GTS to clear the codes.

Chassis > Brake > Clear DTCs
50002 435

b.

Press the DTC clear button.


c.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

4.RECONFIRM DTC
4.RECONFIRM DTC
a.

Operate the GTS to read the DTCs.

Chassis > Brake > Trouble Codes
50001 435

b.

Check if the same DTC is output.


Result:
Result Proceed to
C124A00 is not output A
C124A00 is output B



A

B

5.CHECK CALIBRATION
a.

After replacing the skid control ECU (brake actuator assembly), check that "Calibration" is performed.

HINT:

If a new skid control ECU (brake actuator assembly) was installed, C121054 and C051D54 are output before "Calibration" is performed.



Result:
Result Proceed to
Calibration performed A
Calibration not performed B



A

B