| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C142771 | ABS Pump Motor Actuator Stuck | Actuator pump motor does not operate properly. | ·
Wire harness and connector ·
Brake actuator assembly (Pump motor) ·
Brake actuator assembly (Pump motor circuit) |
Brake |
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Perform the Active Test of the motor relay using the GTS.
| Tester Display | Measurement Item | Control Range | Restrict Condition | Diagnostic Note |
|---|---|---|---|---|
| Motor Relay | ABS motor relay | OFF / ON | Vehicle condition: Vehicle stopped
|
- |
| Tester Display |
|---|
| Motor Relay |
Check the operating sound of the pump motor when operating it using the GTS.
| Result | Proceed to |
|---|---|
| Operating sound is heard | A |
| Operating sound is not heard | B |
A
B
Operate the GTS to clear the codes.
Press the DTC clear button.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Operate the GTS to read the DTCs.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| C142771 is not output | A |
| C142771 is output | B |
If a speed signal of 20 km/h (12 mph) or more is input to the skid control ECU (brake actuator assembly) with the ignition switch ON and the stop light switch assembly off, the ECU performs self-diagnosis of the pump motor circuit.
If the normal system code is output (no DTCs are output), slightly jiggle the connectors, wire harness, and fuses of the skid control ECU (brake actuator assembly).
If any DTCs are output while jiggling a connector or wire harness of the skid control ECU (brake actuator assembly), inspect and repair the connector or wire harness.
If no DTCs were output when reconfirming DTCs, checking for intermittent problems is necessary because it is suspected that the original DTCs were stored due to the poor connection of a connector terminal.
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the A36 skid control ECU (brake actuator assembly) connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A36-1 (GND2) - Body ground | 1 minute or more after disconnecting the cable from the negative (-) auxiliary battery terminal | Below 1 Ω |
Post-procedure1
None
| Proceed to |
|---|
| OK |
| NG |
OK
NG