This procedure is for troubleshooting when the ABS warning light remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the ABS warning light in the combination meter assembly via CAN communication.
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Before performing this procedure, depress the brake pedal and confirm that the stop lights illuminate.
Operate the GTS, and check for DTCs related to the CAN communication system.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| Any CAN communication system relating DTCs are output | A |
| None of the above conditions are met | B |
A
B
Perform the Active Test of the combination meter assembly using the GTS.
| Tester Display |
|---|
| ABS Warning |
Check the combination meter assembly.
The ABS warning light turns on or off in accordance with the GTS operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING