Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY › from 2020.07
RM36W0E _55 Steering _087550 STEERING COLUMN _0424130 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not drop the power steering ECU with motor assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU with motor assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness.

·

Do not allow any moisture to come into contact with the power steering ECU with motor assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign matter to contaminate the power steering ECU with motor assembly.



PROCEDURE

Hide 84450 1.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

a.

Engage the 2 claws and install the ignition or starter switch assembly to the upper steering column bracket assembly.


Hide 2.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)

a.
C434157

Turn the ignition switch to ACC.


b.

Install the ignition switch lock cylinder assembly to the upper steering column bracket assembly.

HINT:

Make sure that the ignition switch lock cylinder assembly is securely fixed onto the upper steering column bracket assembly.



Hide 84052 3.INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

a.

Engage the 2 claws and install the un-lock warning switch assembly to the upper steering column bracket assembly.


Hide 45254B 4.INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER

Hide 45020B 6.INSTALL UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)

a.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Temporarily install the upper steering column bracket with switch assembly and upper steering column clamp with 2 new steering lock set bolts.


c.
C402568

Tighten the 2 steering lock set bolts until the bolt head breaks off.


Hide 45020B 7.INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

HINT:

When replacing the steering lock actuator assembly, refer to Service Bulletin.


a.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Temporarily install the steering lock actuator assembly and upper steering column clamp with 2 new steering lock set bolts.


c.
C399366

Tighten the 2 steering lock set bolts until the bolt head breaks off.