Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER › from 2020.09
RM36W0E _56 Audio / Visual / Telematics _088597 AUDIO / VIDEO _0421925 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 64740C 1.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for 5 Door)

Hide 64740C 2.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for 3 Door)

Hide 86011A 3.REMOVE RADIO SETTING CONDENSER (for 5 Door)

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E439307

Remove the bolt.


b.

Disengage the clamp to disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E439308C01
0,0 0,0 false
V113147

Remove in this Direction


Using a screwdriver, disengage the claws to remove the terminal cover with wire harness from the radio setting condenser as shown in the illustration.


d.
E290011

Using a screwdriver, bend back and break off the claw as shown in the illustration.


e.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.




Hide 86011A 4.REMOVE RADIO SETTING CONDENSER (for 3 Door)

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E453818

Remove the bolt.


b.

Disengage the clamp to disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E439308C01
0,0 0,0 false
V113147

Remove in this Direction


Using a screwdriver, disengage the claws to remove the terminal cover with wire harness from the radio setting condenser as shown in the illustration.


d.
E290011

Using a screwdriver, bend back and break off the claw as shown in the illustration.


e.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.