The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear seat outer belt assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch is turned off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
for 1KR-FE:
Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>REMOVAL
After disconnecting the cable from the negative (-) auxiliary battery terminal, wait for at least 90 seconds to start the operation.
If the airbag deploys for any reason, it may cause a serious accident.
64330D
3.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)
58410B
4.REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)
64771G
5.REMOVE SPARE WHEEL COVER
64716D
6.REMOVE DECK TRIM REAR COVER
7.REMOVE REAR SEAT ASSEMBLY
76973F
8.REMOVE REAR UNDER SIDE COVER (for HV Model)
for LH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
for RH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
67917F
9.REMOVE REAR DOOR SCUFF PLATE INSIDE
62331A
10.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
71303C
11.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY
81330
12.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)
64714C
13.REMOVE DECK TRIM SIDE COVER
64730B
14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY
73360D
15.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY
Remove the bolt to disconnect the floor anchor of the rear seat outer belt assembly.
62471A
16.REMOVE ROOF SIDE INNER GARNISH
73360D
17.REMOVE REAR SEAT OUTER BELT ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, pull out the locking button to release the lock to disconnect the pretensioner connector as shown in the illustration.
| *A | for TMMF Made | *B | for TMC Made |
| *a | Protective Tape | *b | Locking Button |
Remove the bolt (A) to disconnect the shoulder anchor of the rear seat outer belt assembly.
Remove the bolt (B) and then bolt (C).
Disengage the guides to remove the rear seat outer belt assembly.