Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER › from 2020.09
RM36W0E _56 Audio / Visual / Telematics _088597 AUDIO / VIDEO _0421925 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  INSTALLATION  


PROCEDURE

Hide 86011A 1.INSTALL RADIO SETTING CONDENSER (for 5 Door)

a.
E283915

Engage the claw to install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.




b.
E439309C01
0,0 0,0 false
V113147

Install in this Direction


Engage the claws to install the new terminal cover with wire harness to a new radio setting condenser as shown in the illustration.

NOTICE:
·

Do not use excessive force when inserting the terminal covers into the condenser.

·

If a terminal cover has been deformed during installation, replace the terminal, terminal covers and radio setting condenser with new ones.




c.

Engage the clamp to temporarily install the radio setting condenser with wire harness.


d.

Install the radio setting condenser with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 86011A 2.INSTALL RADIO SETTING CONDENSER (for 3 Door)

a.
E283915

Engage the claw to install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.




b.
E439309C01
0,0 0,0 false
V113147

Install in this Direction


Engage the claws to install the new terminal cover with wire harness to a new radio setting condenser as shown in the illustration.

NOTICE:
·

Do not use excessive force when inserting the terminal covers into the condenser.

·

If a terminal cover has been deformed during installation, replace the terminal, terminal covers and radio setting condenser with new ones.




c.

Engage the clamp to temporarily install the radio setting condenser with wire harness.


d.

Install the radio setting condenser with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 64740C 3.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for 5 Door)

Hide 64740C 4.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for 3 Door)