Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK (for 5 Door) › from 2020.09
RM36W0E _58 Vehicle Interior _088479 DOOR LOCK _0447250 FRONT DOOR LOCK(for 5 Door) A

DOOR LOCK  FRONT DOOR LOCK(for 5 Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front door lock assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Window open warning function


(Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Stop and start system *1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the power switch is turned to on (IG), the servo motor standard position is recognized. -


·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 67492A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 74232 4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Hide 74231 5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Hide 67656 6.REMOVE FRONT DOOR TRIM GARNISH

Hide 67602 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68172A 8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67838A 9.REMOVE FRONT DOOR VENT SEAL

Hide 67856B 10.REMOVE FRONT DOOR PANEL PROTECTOR

Hide 67832 11.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68102 12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 68151C 13.REMOVE FRONT DOOR GLASS RUN

Hide 67404F 14.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Hide 69220 15.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)

Hide 16.REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)

Hide 69040A 17.REMOVE FRONT DOOR LOCK ASSEMBLY

a.
B584472

Disconnect the connector.


b.

Using a T30 "TORX" socket wrench, remove the 3 screws.


c.
B584473

Disconnect the front door lock open rod as shown in the illustration.


d.

Remove the front door lock assembly.


e.

When reusing the front door lock assembly:

i.
B584474

Remove the door lock wiring harness seal from the front door lock assembly.



Hide 69720D 18.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)

a.
B584475C01
2.542,0.885 1.792,0.333 true 1.583,0.177 1.792,0.396 0.208,0.219 10 false *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


b.
B584476

Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.


Hide 69720D 19.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)

a.
B584478C01
2.875,0.833 2.438,0.917 true 2.917,0.698 3.125,0.917 0.208,0.219 10 false *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


b.
B584479

Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.


Hide 69760B 20.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)

a.
B584477

Disengage the guide to remove the front door inside locking cable assembly from the front door lock assembly.


Hide 69760B 21.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)

a.
B584480

Disengage the guide to remove the front door inside locking cable assembly from the front door lock assembly.