This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
11115
1.INSTALL CYLINDER HEAD GASKET
Clean the cylinder block sub-assembly and cylinder head sub-assembly with solvent.
| *a | Lot No. |
Place a new cylinder head gasket on the cylinder block sub-assembly with the Lot No. stamp facing upward.
Make sure that the cylinder head gasket is installed in the correct orientation.
11101
2.INSTALL CYLINDER HEAD SUB-ASSEMBLY
13716
3.INSTALL VALVE STEM CAP
13750
4.INSTALL VALVE LASH ADJUSTER ASSEMBLY
13801
5.INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
6.INSTALL NO. 1 CAMSHAFT BEARING CAP
13501A
7.INSTALL INTAKE CAMSHAFT SUB-ASSEMBLY