Home › General › MAINTENANCE › G16E-GTS DRIVE BELT › from 2020.09
RM36W0E _V1 General _088300 MAINTENANCE _0447818 G16E-GTS DRIVE BELT A

MAINTENANCE  G16E-GTS DRIVE BELT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Use a Toyota genuine belt or an equivalent high strength belt when replacing the belt. If a high strength belt is not used, the durability of the belt may be insufficient. A high strength belt is reinforced with an aramid core and is stronger than other belts with a PET (polyester) or PEN (polyethylene naphthalate) core.


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

HINT:

When reusing the fan and generator V belt, check the ribs and back of the fan and generator V belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the fan and generator V belt.


a.
A479665C01
2.219,0.198 2.531,0.396 0.313,0.198 10 false *2 1.104,1.344 1.417,1.542 0.313,0.198 10 false *1 1.969,1.656 2.281,1.854 0.313,0.198 10 false *3 2.063,0.917 2.375,1.115 0.313,0.198 10 false *4
*1 Crankshaft Pulley Assembly
*2 Generator Assembly
*3 Compressor with Pulley Assembly
*4 Water Pump Assembly


Set the fan and generator V belt onto each pulley as shown in the illustration.


b.

Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.


c.
A314804C01
0.552,1.167 0.719,1.333 0.167,0.167 10 false *a 2.198,1.167 2.365,1.333 0.167,0.167 10 false *b
*a Correct
*b Incorrect


After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley by hand.


Hide 51410 3.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY