Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR › from 2020.09
RM36W0E _53 Suspension _087264 REAR SUSPENSION _0447927 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  INSTALLATION  


PROCEDURE

Hide 48812 1.INSTALL REAR STABILIZER BAR

a.
C445852C01
3.156,1.333 3,1.833 true 0.458,0.542 0.615,0.74 0.156,0.198 10 true A 0.427,1.448 0.583,1.646 0.156,0.198 10 true B 2.677,1.438 2.833,1.635 0.156,0.198 10 true B 2.833,0.583 2.99,0.781 0.156,0.198 10 true A 2.927,1.792 3.083,1.99 0.156,0.198 10 true *a
*a Identification Mark


Install the rear stabilizer bar to the rear suspension member sub-assembly with the 4 bolts.

Torque:
78 N*m (795 kgf*cm, 58 ft.*lbf)

NOTICE:
·

Ensure that the identification mark faces the right side of the vehicle.

·

Temporarily tighten bolt (A) and then fully tighten the 2 bolts in the order of (B) and (A).




Hide 48840A 3.INSTALL REAR STABILIZER LINK ASSEMBLY LH

a.
C445849N02
1.583,1.333 1.74,1.531 0.156,0.198 10 true A

Install the rear stabilizer link assembly LH with the nut (A).

Torque:
75 N*m (765 kgf*cm, 55 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.



b.
C445850N02
0.948,1.375 1.104,1.573 0.156,0.198 10 true B

Install the rear stabilizer link assembly LH with the bolt and nut (B).

Torque:
75 N*m (765 kgf*cm, 55 ft.*lbf)

NOTICE:

Tighten the nut with the bolt secured.



c.

Install the cap.


Hide 48830D 4.INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 5.INSTALL REAR WHEEL