Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL OIL TEMPERATURE SENSOR › from 2020.09
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0447993 DIFFERENTIAL OIL TEMPERATURE SENSOR A

AXLE AND DIFFERENTIAL  DIFFERENTIAL OIL TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leaks from exhaust system Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY

Hide 89429A 2.REMOVE TEMPERATURE SENSOR

a.
C450352

Disconnect the temperature sensor connector.


b.
C450353E01
1.438,1.229 1.854,0.99 true 1.063,1.25 1.396,1.448 0.333,0.198 10 true SST

Using SST, remove the temperature sensor and gasket.

SST
09729-00220