Home › Engine / Hybrid System › G16E-GTS (INTAKE / EXHAUST) › EXHAUST PIPE › from 2020.09
RM36W0E _51 Engine / Hybrid System _095906 G16E-GTS INTAKE / EXHAUST _0449875 EXHAUST PIPE A

G16E-GTS INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A481180

Remove the 2 bolts and disconnect the tail exhaust pipe assembly from the front exhaust pipe assembly.


b.

Remove the tail exhaust pipe assembly from the 3 exhaust pipe supports.


c.

Remove the exhaust pipe gasket from the front exhaust pipe assembly.


Hide 51447D 2.REMOVE CENTER NO. 4 ENGINE UNDER COVER

a.
A480439

Remove the 4 bolts and center No. 4 engine under cover from the vehicle body.


Hide 57533B 3.REMOVE FRONT FLOOR CENTER BRACE

a.
A480440

Remove the bolt and front floor center brace from the center No.1 floor brace.


Hide 57543C 4.REMOVE CENTER NO. 1 FLOOR BRACE

a.
A480441

Remove the 2 nuts and center No. 1 floor brace from the body.


Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A480443

Remove the 2 bolts and 2 compression springs and disconnect the front exhaust pipe assembly from the exhaust manifold converter sub-assembly.


b.

Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.


c.

Remove the exhaust pipe gasket from the exhaust manifold converter sub-assembly.