89429A
1.INSTALL TEMPERATURE SENSOR
| *a | Torque Wrench Fulcrum Length |
Using SST, install a new gasket and temperature sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 200 mm (7.87 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 14.2 N*m (145 kgf*cm, 10 ft.*lbf)
Connect the temperature sensor connector.
17430
2.INSTALL TAIL EXHAUST PIPE ASSEMBLY
3.INSPECT FOR EXHAUST GAS LEAK