Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for 4-Pot Caliper) › from 2020.09
RM36W0E _54 Brake _089428 BRAKE (FRONT) _0448422 FRONT BRAKE(for 4-Pot Caliper) A

BRAKE (FRONT)  FRONT BRAKE(for 4-Pot Caliper)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·
C444644N01
0.979,0.438 1.125,0.604 0.146,0.167 10 true A 1.125,1.677 1.271,1.844 0.146,0.167 10 true B

To avoid degrading the precision of the assembly, do not loosen or remove the 2 bolts shown in the illustration.

·

If the bolts have been loosened or removed, use the following procedure to reassemble the parts.

(a)

Temporarily install the front disc brake cylinder assembly with the 2 bolts.

(b)

Start the engine.

(c)

Depress the brake pedal to continuously apply hydraulic pressure.

(d)

Temporarily tighten bolt A to 30 N*m (306 kgf*cm, 22 ft.*lbf).

(e)

Temporarily tighten bolt B to 30 N*m (306 kgf*cm, 22 ft.*lbf).

(f)

Fully tighten bolt A to 100 N*m (1020 kgf*cm, 74 ft.*lbf).

(g)

Fully tighten bolt B to 100 N*m (1020 kgf*cm, 74 ft.*lbf).

(h)

Release the brake pedal to release the hydraulic pressure.

(i)

Check that the 2 bolts are tightened to 100 N*m (1020 kgf*cm, 74 ft.*lbf).




HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 47749 3.REMOVE FRONT DISC BRAKE PIN HOLD CLIP

Hide 47748B 4.REMOVE FRONT DISC BRAKE ANTI-RATTLE PIN

Hide 47748 5.REMOVE FRONT DISC BRAKE ANTI-RATTLE SPRING

Hide 04465 6.REMOVE FRONT DISC BRAKE PAD

Hide 04945 7.REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT

Hide 47313J 8.DISCONNECT FRONT FLEXIBLE HOSE

a.
C447940

Remove the union bolt and gasket, and disconnect the front flexible hose from the front disc brake cylinder assembly.


Hide 47750 9.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY

a.
C447941

Remove the 2 bolts and front disc brake cylinder assembly from the steering knuckle.


Hide 43516 10.REMOVE FRONT DISC

a.
C447942C01
1.854,1.094 2.5,1.24 2.5,1.24 1.802,1.01 true 2.542,1.156 2.854,1.313 0.313,0.156 10 false *a
*a Matchmark


Put matchmarks on the front disc and the front axle hub sub-assembly.

HINT:

Not required when replacing the front disc.



b.

Remove the front disc from the front axle hub sub-assembly.