Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
43516
1.INSTALL FRONT DISC
Check the identification marks and confirm the installation positions.
The front disc needs to be installed to the correct side of the vehicle. There is a "L", indicating the disc for the left wheel, or a "R", indicating the disc for the right wheel, engraved on the disc in the position shown in the illustration.
When reusing the front disc:
| *a | Matchmark |
Align the matchmarks of the front disc and front axle hub sub-assembly, and install the front disc.
When replacing the front disc:
Inspect the front disc runout.
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for 4-Pot Caliper)>INSPECTION
Select the installation position where the front disc has minimal runout, and install the front disc.
Temporarily install the 5 hub nuts.
47750
2.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY
Install the front disc brake cylinder assembly to the steering knuckle with the 2 bolts.
47313J
3.CONNECT FRONT FLEXIBLE HOSE
Connect the front flexible hose to the front disc brake cylinder assembly with a new union bolt and a new gasket.
Install the front flexible hose lock securely into the lock hole in the front disc brake cylinder assembly.
04945
4.INSTALL FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
04465
5.INSTALL FRONT DISC BRAKE PAD
47748
6.TEMPORARILY INSTALL FRONT DISC BRAKE ANTI-RATTLE SPRING
47748B
7.INSTALL FRONT DISC BRAKE ANTI-RATTLE PIN
47749
8.INSTALL FRONT DISC BRAKE PIN HOLD CLIP
9.BLEED BRAKE LINE
10.INSTALL FRONT WHEEL