Home › Engine / Hybrid System › G16E-GTS (EMISSION CONTROL) › EMISSION CONTROL SYSTEM › from 2020.09
RM36W0E _51 Engine / Hybrid System _095691 G16E-GTS EMISSION CONTROL _0449380 EMISSION CONTROL SYSTEM G

G16E-GTS EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A345137

·

When working near the engine room while the engine has started or the power source mode is ignition switch to ON (IG), do not touch the fan and generator V belt or rotating components such as the fan, etc.

·

Touching the fan and generator V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.



PROCEDURE

Hide 1.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose or other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body assembly and cylinder head sub-assembly will cause engine failure or engine malfunctions.



If any defects are found, replace parts as necessary.


Hide 2.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

CAUTION:
·

When working near the engine room while the engine has started or the power source mode is ignition switch to ON (IG), do not touch the fan and generator V belt or rotating components such as the fan, etc.

·

Touching the fan and generator V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.



a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Warm up the engine.


d.

Turn the GTS on.


e.

Slide the clip and disconnect the fuel vapor feed hose from the purge valve (purge VSV).


f.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the EVAP Purge VSV.

Powertrain > Engine > Active Test
Tester Display
Activate the EVAP Purge VSV
50004 372 1

g.

Check that vacuum occurs at the purge valve (purge VSV) port.


h.

If vacuum does not occur, check the following items:

·

Purge valve (purge VSV)

·

Clogs in the fuel vapor feed hose that connects the intake manifold and purge valve (purge VSV)



i.

Exit Active Test mode and connect the fuel vapor feed hose and slide the clip to secure it.


j.

Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.

Powertrain > Engine > Data List
Tester Display
EVAP (Purge) VSV
50003 372 226

k.

Warm up the engine and drive the vehicle.


l.

Confirm that the purge valve (purge VSV) opens.

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.