36100A
1.INSTALL TRANSFER AND TRANSAXLE SETTING STUD BOLT
36100
2.INSTALL TRANSFER ASSEMBLY
Clean the bolt holes.
Using SST and union nut wrench, install the transfer assembly to the transaxle with the 6 nuts and 2 bolts.
| *a | Union Nut Wrench | *b | Torque Wrench Fulcrum Length |
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 30 mm (1.181 in.)) + SST (fulcrum length of 150 mm (5.906 in.)) + torque wrench (fulcrum length of 255 mm (10.039 in.)): 40.2 N*m (410 kgf*cm, 30 ft.*lbf)
30300
3.INSTALL MANUAL TRANSAXLE ASSEMBLY
4. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART