Home › General › MAINTENANCE › G16E-GTS AUXILIARY BATTERY › from 2020.09
RM36W0E _V1 General _088300 MAINTENANCE _0449415 G16E-GTS AUXILIARY BATTERY A

MAINTENANCE  G16E-GTS AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.



Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A474211

Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.


Hide 4.REMOVE AUXILIARY BATTERY

a.
A474212

Disengage the claw to remove the fusible link cover.


b.

Loosen the nut.


c.
A474214C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the spring assembly and disconnect the cable from the positive (+) auxiliary battery terminal.


d.
A474216

Disconnect the battery hose from the auxiliary battery.


e.
A474215

Remove the nut, bolt and battery clamp sub-assembly from the body.


f.

Remove the auxiliary battery.