89429A
1.INSTALL TEMPERATURE SENSOR
| *a | Torque Wrench Fulcrum Length |
Using SST, install a new gasket and temperature sensor to the manual transaxle assembly.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a SST (fulcrum length of 200 mm (7.87 in.))) + torque wrench (fulcrum length of 180 mm (7.09 in.))): 18.6 N*m (190 kgf*cm, 14 ft.*lbf)
Connect the temperature sensor connector.
51410
2.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY