1.REMOVE SELECTING BELL CRANK ASSEMBLY
Remove the 2 bolts and selecting bell crank assembly from the manual transmission case.
2.REMOVE CONTROL SHIFT LEVER BUSHING
Remove the control shift lever bushing from the selecting bell crank assembly.
3.REMOVE NO. 1 SELECTING BELL CRANK DUST COVER
Remove the No. 1 selecting bell crank dust cover from the selecting bell crank assembly.
84210
4.REMOVE BACK-UP LIGHT SWITCH ASSEMBLY
84545
5.REMOVE NEUTRAL POSITION SWITCH
33290
6.REMOVE NO. 1 LOCK BALL ASSEMBLY
33290B
7.REMOVE NO. 2 LOCK BALL ASSEMBLY
33295B
8.REMOVE SHIFT GATE PIN
9.REMOVE SHIFT AND SELECT LEVER ASSEMBLY
Remove the 4 bolts and shift and select lever assembly from the manual transmission case.
33251A
10.REMOVE NO. 1 SHIFT LEVER INNER
Using a pin punch and hammer, remove the slotted spring pin from the No. 1 shift lever inner.
Remove the No. 1 shift lever inner and shift interlock plate from the shift and select lever shaft.
33261C
11.REMOVE SHIFT AND SELECT LEVER SHAFT
Remove the control shaft cover and the shift and select lever boot from the shift and select lever shaft.
33266C
12.REMOVE SHIFT GATE PLATE
Remove the 2 bolts and shift gate plate from the No. 1 shift lever inner.
33111J
13.REMOVE PIN
Remove the 2 pins from the No. 1 shift lever inner.
33544C
14.REMOVE SHIFT LEVER DAMPER
Remove the 2 bolts and shift lever damper from the shift lever shaft.
33528C
15.REMOVE CONTROL SHAFT COVER OIL SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the control shaft cover oil seal from the control shaft cover.