Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › THROTTLE BODY › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449857 THROTTLE BODY A

G16E-GTS ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 17360A 2.REMOVE AIR TUBE ASSEMBLY

a.
A481034

Remove the 4 bolts and air tube assembly from the throttle body with motor assembly.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



b.

Remove the No. 2 throttle body gasket from the air tube assembly.


Hide 22030 3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A481033

Remove the throttle body with motor assembly from the intake manifold.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



b.

Remove the throttle body gasket from the intake manifold.