Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449861 CRANKSHAFT POSITION SENSOR A

G16E-GTS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 28100 1.REMOVE STARTER ASSEMBLY

Hide 11401G 2.REMOVE CRANKSHAFT POSITION SENSOR

a.
A480397

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.



c.
A480883

Remove the O-ring from the crankshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.

·

If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.