Home › Engine / Hybrid System › G16E-GTS (STARTING) › STARTER › from 2020.09
RM36W0E _51 Engine / Hybrid System _095693 G16E-GTS STARTING _0449410 STARTER A

G16E-GTS STARTING  STARTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When the starter assembly is replaced, "ST NO. 1 relay" must also be replaced.



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 51410 3.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 16283 4.DISCONNECT NO. 6 WATER BY-PASS HOSE

a.
A471549

Disconnect the No. 6 water by-pass hose from the oil cooler hose.


Hide 16282 5.DISCONNECT NO. 5 WATER BY-PASS HOSE

a.
A471550

Disconnect the No. 5 water by-pass hose from the oil cooler hose.


Hide 15710 6.REMOVE OIL COOLER ASSEMBLY

a.
A471551

Remove the 3 bolts and oil cooler assembly from the oil pan sub-assembly.


b.
A471552

Remove the 2 o-rings.


Hide 11363A 7.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A471553

Disconnect the claw as shown in the illustration to remove the flywheel housing side cover.


Hide 28100 8.REMOVE STARTER ASSEMBLY

a.
A471554

Disconnect the 2 starter assembly connectors.


b.

Open the terminal cap.


c.
A471555

Disengage the clamp to separate the engine wire.


d.

Remove the nut and disconnect the engine wire from terminal 30.


e.
A471556

Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.


f.
A476029

Remove the bolt and wire harness clamp bracket from the starter assembly.