Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449861 CRANKSHAFT POSITION SENSOR A

G16E-GTS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A480883

Clean the O-ring groove of the crankshaft position sensor.

NOTICE:

Make sure the O-ring groove is free of foreign matter.



b.

Install a new O-ring to the crankshaft position sensor.

NOTICE:

Set the O-ring on the tip of the crankshaft position sensor and roll it into the O-ring groove with bare hands to install it.



c.

Check if the O-ring is twisted.


d.
A480397

Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or does not move out of place during installation.




e.

Connect the crankshaft position sensor connector.


Hide 28100 2.INSTALL STARTER ASSEMBLY

Hide 3.INSPECT FOR ENGINE OIL LEAK