Home › Engine / Hybrid System › G16E-GTS (STARTING) › STARTER › from 2020.09
RM36W0E _51 Engine / Hybrid System _095693 G16E-GTS STARTING _0449410 STARTER A

G16E-GTS STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the wire harness clamp bracket to the starter assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)


c.

Connect the engine wire to terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the clamp.


e.

Close the terminal cap.


f.

Connect the 2 starter assembly connectors.


Hide 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

a.
A478829

Align the protrusion with the cylinder block sub-assembly and attach the claw as shown in the illustration to install the flywheel housing side cover.

NOTICE:
·

Make sure the claw makes a click sound, indicating that it fits tightly.

·

Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.




Hide 15710 3.INSTALL OIL COOLER ASSEMBLY

a.

Install 2 new oil cooler gaskets to the oil cooler assembly.


b.

Install the oil cooler assembly to the cylinder block sub-assembly with the 2 nuts and bolt.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 16282 4.CONNECT NO. 5 WATER BY-PASS HOSE

a.

Connect the No. 5 water by-pass hose to the oil cooler assembly, and slide the clip to secure them.


Hide 16283 5.CONNECT NO. 6 WATER BY-PASS HOSE

a.

Connect the No. 6 water by-pass hose to the oil cooler assembly, and slide the clip to secure them.


Hide 51410 6.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 8. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function thatcompletes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART