Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 2) › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449866 AIR FUEL RATIO SENSOR(for Sensor 2) A

G16E-GTS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 2)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 2 air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
·

Replacement of air fuel ratio sensor (sensor 2)

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A344784

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

·

Touching high-temperature areas such as the engine and exhaust pipe could result in burns.



PROCEDURE

Hide 51447D 1.REMOVE CENTER NO. 4 ENGINE UNDER COVER

Hide 57533B 2.REMOVE CENTER FRONT FLOOR BRACE

Hide 57543C 3.REMOVE CENTER NO. 1 FLOOR BRACE

Hide 89467C 4.REMOVE NO. 2 AIR FUEL RATIO SENSOR

a.
A480405

Disconnect the No. 2 air fuel ratio sensor connector.


b.

Disengage the 3 wire harness clamps.


c.
A480885N01
2.063,0.74 2.708,0.344 true 2.719,0.188 3.177,0.385 0.458,0.198 10 true SST

Using SST, remove the No. 2 air fuel ratio sensor from the front exhaust pipe assembly.

SST
09224-00012  

NOTICE:

If the No. 2 air fuel ratio sensor has been struck or dropped, replace it.