Home › Engine / Hybrid System › G16E-GTS (COOLING) › THERMOSTAT › from 2020.09
RM36W0E _51 Engine / Hybrid System _095909 G16E-GTS COOLING _0449889 THERMOSTAT A

G16E-GTS COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the water inlet with thermostat sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Cleaning the deposits from the throttle body with motor assembly Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 16032 1.REMOVE WATER INLET WITH WATER PUMP HOUSING SUB-ASSEMBLY

Hide 16031 2.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A480881

Remove the 2 bolts and water inlet with thermostat sub-assembly.


b.
A480882

Remove the gasket from the water inlet with thermostat sub-assembly.