Home › Engine / Hybrid System › G16E-GTS (COOLING) › WATER PUMP › from 2020.09
RM36W0E _51 Engine / Hybrid System _095909 G16E-GTS COOLING _0449888 WATER PUMP A

G16E-GTS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Cleaning the deposits from the throttle body with motor assembly Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 2.DRAIN ENGINE COOLANT

Hide 16173 4.REMOVE WATER PUMP PULLEY

a.
A480880

Loosen the 4 bolts holding the wate pump pulley.


b.

Remove the fan and generator V-belt.

Click hereGeneral>MAINTENANCE>G16E-GTS DRIVE BELT>REMOVAL


c.

Remove the 4 bolts and water pump pulley.


Hide 16282 6.REMOVE NO. 5 WATER BY-PASS HOSE

a.
A473351

Slide the clip and disconnect the No. 5 water by-pass hose from the water inlet with water pump housing sub-assembly.


Hide 16572D 7.REMOVE NO. 2 RADIATOR HOSE

a.
A473352

Slide the clip and disconnect the No. 2 radiator hose from the water inlet.


Hide 17871 8.REMOVE AIR CONNECTOR STAY

a.
A473353

Remove the bolt and air connector stay from the water inlet with water pump housing sub-assembly.


Hide 16032 9.REMOVE WATER INLET WITH WATER PUMP HOUSING SUB-ASSEMBLY

a.
A480355

Slide the clip and disconnect the No. 4 water by-pass hose from the water inlet with thermostat sub-assembly.

NOTICE:
·

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 4 water by-pass hose.

·

Do not damage the water inlet with thermostat sub-assembly.




b.
A480448

Remove the bolt, 2 nuts and water inlet with water pump housing sub-assembly from the cylinder block sub-assembly.


c.
A480463

Remove the gasket from the water inlet with water pump housing sub-assembly.


Hide 16031 10.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY