Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › ACTIVE TORQUE SPLIT AWD SYSTEM › from 2020.09
RM36W0E _52 Drivetrain _095692 GF1A TRANSFER / 4WD / AWD _0449992 ACTIVE TORQUE SPLIT AWD SYSTEM J

GF1A TRANSFER / 4WD / AWD  ACTIVE TORQUE SPLIT AWD SYSTEM  4WD Warning Light does not Come ON  


WIRING DIAGRAM

CAUTION / NOTICE / HINT

PROCEDURE

1.CHECK HARNESS AND CONNECTOR
a.

Check that there is no looseness at the locking and connecting parts of the 4WD ECU assembly connector.

OK:

No looseness at the locking and connecting parts



b.

Disconnect the O119 and O120 4WD ECU assembly connectors.


c.

Check the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion



d.

Connect the O119 and O120 4WD ECU assembly connectors.


Result:
Proceed to
OK
NG



OK

2.CHECK 4WD WARNING MESSAGE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK 4WD WARNING MESSAGE
a.

According to the display on the GTS, perform the Active Test and check the Data List "4WD Warning Light" turns ON/OFF.

Chassis > Four Wheel Drive > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
4WD Warning Light 4WD/AWD warning (multi-information display) OFF / ON OFF: Warning off
ON: Warning on
-
Chassis > Four Wheel Drive > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
4WD Warning Light 4WD/AWD warning (multi-information display) Warning ON/OFF Observe combination meter assembly
Chassis > Four Wheel Drive > Active Test
Active Test Display
4WD Warning Light
Data List Display
4WD Warning Light
50004 448 1 114

Result:
Result Proceed to
Data List display does not switch ON/OFF A
Data List display switches ON/OFF B



A

B

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)