Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › ACTIVE TORQUE SPLIT AWD SYSTEM › from 2020.09
RM36W0E _52 Drivetrain _095692 GF1A TRANSFER / 4WD / AWD _0449992 ACTIVE TORQUE SPLIT AWD SYSTEM C

GF1A TRANSFER / 4WD / AWD  ACTIVE TORQUE SPLIT AWD SYSTEM  C120C1C  Linear Solenoid Power Supply System Circuit Voltage Out of Range  


DESCRIPTION

When a malfunction has occurred in the linear solenoid power source system, the 4WD ECU assembly stores DTC C120C1C.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
C120C1C Linear Solenoid Power Supply System Circuit Voltage Out of Range When the IG1 terminal voltage is 9.5 V or more and less than 17.0 V, the BSLC terminal voltage is less than 9.5 V for 1 second.
·

Wire harness or connector

·

4WD ECU assembly


Displayed Yes

WIRING DIAGRAM

C367130E08
1.896,0.802 2.844,0.99 0.948,0.188 10 false ECU-B NO. 3 4.833,0.51 5.073,0.76 0.24,0.25 10 false 2 4.823,1.188 4.979,1.385 0.156,0.198 10 false 1 5.125,0.635 5.583,0.833 0.458,0.198 10 false BSLC 5.125,1.333 5.583,1.531 0.458,0.198 10 false GND 4.99,1.833 5.5,2.042 0.51,0.208 10 false O119 5,2 6.781,2.281 1.781,0.281 10 false 4WD ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

·

When the 4WD ECU assembly is replaced, before removing the 4WD ECU assembly, it is necessary to perform ECU Data Save to save the original 4WD ECU assembly information.

Click hereDrivetrain>GF1A (TRANSFER / 4WD / AWD)>ACTIVE TORQUE SPLIT AWD SYSTEM>CALIBRATION

·

After performing repairs, clear the DTCs and check that the DTCs are not output again.

Click hereDrivetrain>GF1A (TRANSFER / 4WD / AWD)>ACTIVE TORQUE SPLIT AWD SYSTEM>DTC CHECK / CLEAR



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BSLC TERMINAL)
a.

Turn the ignition switch off.


b.

Disconnect the O119 4WD ECU assembly connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
O119-2 (BSLC) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (GND TERMINAL)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (GND TERMINAL)
a.

Turn the ignition switch off.


b.

Disconnect the O119 4WD ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
O119-1 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR