When a malfunction has occurred in the power source circuit, the 4WD ECU assembly stores DTC C123A1C.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory |
|---|---|---|---|---|---|
| C123A1C | Supply Voltage Circuit Circuit Voltage Out of Range | ·
At a vehicle speed of 3 km/h (2 mph) or more, the IG1 terminal voltage is less than 9.5 V for 10 seconds or more ·
The IG1 terminal voltage is 17 V or more for 3 seconds or more |
·
Wire harness or connector ·
4WD ECU assembly |
Displayed | Yes |
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
| Diagnosis Condition | The vehicle speed is 3 km/h (2 mph) or more | ○ | - |
| Malfunction Status | The IG1 terminal voltage is less than 9.5 V | ○ | - |
| The IG1 terminal voltage is 17 V or more | - | ○ | |
| Detection Time | 10 seconds or more | 3 seconds or more | |
| Number of Trips | 1 trip | 1 trip | |
DTC will be output when conditions for either of the patterns in the table above are met.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When the 4WD ECU assembly is replaced, before removing the 4WD ECU assembly, it is necessary to perform ECU Data Save to save the original 4WD ECU assembly information.
Click hereDrivetrain>GF1A (TRANSFER / 4WD / AWD)>ACTIVE TORQUE SPLIT AWD SYSTEM>CALIBRATION
After performing repairs, clear the DTCs and check that the DTCs are not output again.
Click hereDrivetrain>GF1A (TRANSFER / 4WD / AWD)>ACTIVE TORQUE SPLIT AWD SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Disconnect the O119 4WD ECU assembly connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| O119-24 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Disconnect the O119 4WD ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O119-1 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG